|
Quality Medical Inc.
4829 S. Kirk Way.
Aurora, CO 80015
1-877-878-9882
1-800-846-7609 - Fax
|
|
Back to Cast Accessories
Instructions for Wearing
the Dry Pro - Formally known as XeroSox
Waterproof Cast and Bandage Cover |
|
1. Slide on Dry Pro - Stretch on the
Dry Pro waterproof bandage cover so that it completely covers the cast
or bandage plus an additional inch. The top should be smooth against
the skin. Be careful of sharp objects. A fingernail, sharp fiberglass
threads on a cast, can rip the Dry Pro cast and bandage protector. Putting
a soft ace bandage or a tube sock with the toe cut out over the fiberglass
cast will help reduce sharp fiberglass threads from cutting into the
waterproof bandage cover. Only if the Dry Pro cast protector feels too tight, you may trim the top slightly to increase the opening. Do this little by little 1/8" at a time until the opening is comfortable, but smaller than the limb. Always leave at least 2" of material above the pump. |
|
2. Pump out the air - Continue to press
the bulb until it remains flat and the Dry Pro waterproof clothing is
completely wrinkled. Remove the pump and push on the safety cap. Observe
the Dry Pro waterproof cast and bandage cover for a few minutes before
going in the water. As long as the Dry Pro waterproof cover stays
collapsed and wrinkled, the vacuum is intact and the Dry Pro bandage
protector cannot leak or come off. |
|
3. Slide off - When you are done using
the Dry Pro waterproof clothing, simply lift up the cuff to let the air
back in. The Dry Pro waterproof bandage cover should now be loose. Simply
slide it back off. |
Note - Do
not leave on for extended periods of time. We recommend removing it
after every 45 minutes of use. Do not use in vascular compromised patients.
Steady yourself in wet slippery areas. The Dry Pro cast and bandage
protector contains natural rubber latex, which may cause allergic reactions.
Always follow your doctor's advice. |
We will match any online advertised price for Dry Pro!
You also get professional help with sizing and our protectors are in stock and ready to ship.
Just call 1-877-878-9882
 |
Dry Pro
Cast Protectors - In Stock & Lowest Price
The Stay Dry Pro Pump is Completely Watertight.
Keeping your Bandages, Prosthesis, and Casts Dry. The Stay Dry Pro-Pump is a surgical latex sleeve that fits over a cast to offer complete waterproof protection. Its patented vacuum seal assures that a cast will stay dry, even when submerged in water.
With the Stay Dry Pro-Pump , patients can go swimming, bathe, shower and receive hydrotherapy. The Stay Dry Pro-Pump is the world's only true waterproof body protection!
You must follow the measurement instructions correctly for a proper fit and seal!!
Same Day shipping on orders placed by 12pm MST
Overnight Delivery Available!!
1-3 Day Ground Delivery!!
(Delivery to most Continental U.S. destinations.) |
 |
Click here for measurement instructions: (Measurement
Instructions)
Click here to learn how to use the Dry Pro Cast Protector: (How
to Use)
Click here for common FAQ’s about Dry Pro: (FAQ)
Note -
Do not leave on for extended periods of time. We recommend removing it
after every 45 minutes of use. Do not use in vascular compromised patients.
Steady yourself in wet slippery areas. The Dry Pro cast and bandage protector
contains natural rubber latex, which may cause allergic reactions. Always
follow your doctor's advice. We sell only new items, cast protectors are non-returnable, please measure carefully!
Don't worry if the Dry Pro waterproof cast
cover is too long. The excess material of the cast sock
will flatten down when the air is pumped out.
Choose a cast protector with enough length and the circumference within the range of your measurement.
Measure around the skin and not the cast! |
|
 |
Dry Pro Cast Protector – Full Arm(X-Small)
- SKU QMFA-12
Length - 16 in (40 cm) Arm Circumference - 6-6.75 inches |
$
31.95 |
|
Dry Pro Cast Protector – Full Arm(Small)
- SKU QMFA-14
Length - 23 in (58 cm) Arm Circumference - 6.75-8.75 inches |
$
33.95 |
|
Dry Pro Cast Protector – Full Arm(Medium)
- SKU QMFA-16
Length - 28 in (71 cm) Arm Circumference - 8.75-10 inches |
$
35.95 |
|
Dry Pro Cast Protector – Full Arm(Large)
- SKU QMFA-18
Length - 31.5 in (80 cm) Arm Circumference - 10 inches and up |
$
35.95 |
|
Dry Pro Cast Protector – Half Arm(Small)
- SKU QMHA-13
Length - 17.25 in (43 cm) Arm Circumference - 7.75-10 inches |
$
33.95 |
|
Dry Pro Cast Protector – Half Arm -
SKU QMHA-15
Length - 20 in (51 cm) Arm Circumference - 10 inches and up |
$
35.95 |
|
Dry Pro Cast Protector – Full Leg(X-Small)
- SKU QMFL-12
Length - 19 in (48 cm) Leg Circumference -7.5-11 inches |
$
31.95 |
|
Dry Pro Cast Protector – Full Leg(Small)
- SKU QMFL-14
Length - 29 in (73 cm) Leg Circumference - 14-16.5 inches |
$
33.95 |
|
Dry Pro Cast Protector – Full Leg(Medium)
- SKU QMFL-16
Length - 32.5 in (82 cm) Leg Circumference - 16.5-21 inches |
$
35.95 |
|
Dry Pro Cast Protector – Full Leg(Large)
- SKU QMFL-18
Length - 37 in (94 cm) Leg Circumference - 21 inches and up |
$
35.95 |
|
Dry Pro Cast Protector – Half Leg(Small)
- SKU QMHL-13
Length - 21in (53cm) Leg Circumference - 10-13 inches |
$
33.95 |
|
Dry Pro Cast Protector – Half Leg(Large)
- SKU QMHL-15
Length - 23.5 in (59 cm) Leg Circumference - 13 inches and up |
$
35.95 |
|
Specifications:Package
size is 1 each.
This item is warrantied by the manufacturer. |
|
